A wide variety of Fittings is available to complement Curtain Rods.
Only a small selection of Fittings is shown below. This Duke Rod has a Flat Knob to finish off the Rod if there is no space for a Finial. All articles have three coats of paint to ensure a high quality finish and to give you decades of use. This Rod is manufactured in Jelutong wood, which is warp-free.
We are here to advise and help you.
Fittings &Accessories
Knobs
Flat Knob
(in jelutong) 3,8 cm Ø 5,0 cm Ø 6,3 cm Ø 7,5 cm Ø 8,3 cm Ø 9,0 cm Ø 10,0 cm Ø
Domed Knob
(in obeche) 6,2 cm Ø only
Bell-push Knob
(in pine) 110 mm Ø x 29 mm thick Can be machined to smaller diameter.
Rope Knob
(in resin) For 6,3 cm Ø Rod - cap fit For 7,5 cm Ø Rod
Radial Knob
(in pine) For 6,3 cm Ø Rod - cap fit
Tiered Knob
(in pine) For 6,3 cm Ø Rod & 62 mm Ø Pole - cap fit
CENTRE PIECES, JOINT COVERS & BANGLES
Joint Cover
(in PVC)
Corner Cover
(in PVC)
2-Ring Centre Piece
(in jelutong) 3-Ring Centre Piece (in jelutong) Bangle (in pine)
Rope-wrapped Joint Cover
(in Resin) for 6,3 cm Ø Rod
Rope-wrapped Corner Cover
(in Resin) for 6,3 cm Ø Rod
BRACKETS
Middle Support
(in metal) for all Rod diameters
Wooden
(in jelutong) for all Rod diameters
Corner
(in metal) for all Rod diameters
Solid Brass
5,0 cm Ø and 6,3 cm Ø Rods
L-design Overhead
(in metal) for all Rod diameters
JELUTONG SQUARE FITTINGS
Z-ceiling Bracket
(in metal) for 6.3 cm Ø
and 7.5 cm Ø Rods
Rosettes
(in jelutong) for most Rod diameters
Single Pine
for 33 mm Ø Poles
Double Pine
for 33 mm Ø Poles
Square Knob
63 mm75 mm
Cube Finial
63 mm75 mm
Diamond Finial
Square Finial
Square Hold-back
Diamond Hold-back
Square Joint Covers and Square Corner Covers available in metal.
MAGNETIC HOLD-BACKS
The latest innovation in Magnetic Hold-backs for curtains.
Available either with 25 cm long cable or 45 cm cable; Finished to the same colour as your order.
